Epson S1C62 Family - Manual (Page 132)

ICE CONTROL SOFTWARE ICS62XX
VIII-18 EPSON S1C62 FAMILY
DEVELOPMENT TOOL REFERENCE MANUAL
3 COMMAND DETAILS
Detailed particulars on ICE commands and explanations of functions are described in this section.
Commands are divided into six categories.
DISPLAY: This command group displays the contents of program memory and data memory, and
history information.
SET: This group of commands modifies the contents of memory (program and data
memories).
BREAK and GO: Sets break conditions and starts emulations.
FILE: Controls transfer of files from the host to the ICE.
ROM: Controls the transfer of program memory and ROM (high and low) used by the evalua-
tion board CPU.
CONTROL: Sets the ICE operation mode (including initialization of the target system).
An S1C6S3N7/6S3B7/6S3L7 program is used in the examples, but output error messages may differ with
the type of device used.
The methods for entering instructions described in Section 3.1 are as follows:
• A # mark is displayed when the program awaits instructions.
• Upper and lower case letters may be used to enter instructions.
• Individual instructions delineated by < > marks in the text should be separated by a comma when
entering instructions.
• Interactive instructions imbeded in commands are displayed by key input. The interactive portions of
instructions in the following examples are underlined in the text.
• The toggle instruction is set to reverse upon each command input.
• Notes indicates points for caution when using the described commands.