Epson S1C62 Family - Manual (Page 12)

INTRODUCTION
I-2 EPSON S1C62 FAMILY
DEVELOPMENT TOOL REFERENCE MANUAL
2 DEVELOPMENTAL ENVIRONMENT
The software product of the development support tool S5U1C62xxxD operates on the following host
systems:
• IBM PC/AT (at least PC-DOS Ver. 2.0)
When developing the S1C62XXX, the above-mentioned host computer, editor, P-ROM writer, printer, etc.
must be prepared by the user in addition to the development tool which is normally supported by Seiko
Epson.
Host computer
(IBM PC/AT)
Software tools
Hardware tools
Target board
PC-DOS
Editor
• P-ROM writer
• Printer
To be prepared by the user
S5U1C62000A
ICE Evaluation Board
S5U1C62xxxE
S1C62xxx Development Tool
S5U1C62000H
S5U1C62xxxD
DMS6200 SOG62xx
ASM62xx ICS62xx
MLA628x MDC62xx
FOG62xx
RS-232C
Fig. 2.1 System configuration
Note The S5U1C62xxxD system requires a host computer with a RAM capacity of about 140K bytes.
Since the ICE (S5U1C62000H) is connected to the host computer with a RS-232C serial interface,
adapter board for asynchronous communication will be required depending on the host computer
used.
3 DEVELOPMENT FLOW
Figure 3.1 shows the development flow through the S5U1C62xxxD.
Concerning file names
All the input-output file name for the each development support tool commonly use "C2XXYYY". In
principle each file should be produced in this manner. Seiko Epson will designate the "YYY" for each
customer.