Emerson Liebert IntelliSlot IS-WEB485ADPT - Manual (Page 56)

Updating the Firmware - Xmodem (Serial) Method
A12
Complete the Upgrade and Restore Communication Rate
22. Choose 9600 bps from the menu, shown below left.
23. From the HyperTerminal menu, click on Call, then choose Disconnect (this will not close the
HyperTerminal connection to the card).
24. In the HyperTerminal menu bar, click on File, then choose Properties.
25. Click on the Connect To tab and click the Configure button. This opens Port Settings tab in the
COM1 Properties window, as shown below right.
26. Choose 9600 from the Bits Per Second drop-down list and click OK, then click OK to close the
Properties window.
27. In the HyperTerminal menu bar, click on Call, then choose Call from the drop-down menu.
28. Press the Enter key.
29. Choose Exit and Save from the Main Menu to reboot the card.
When rebooting is complete, the upgrade is finished.
Check the new firmware version if you wish (see A.3.2 - Determine
the Liebert IntelliSlot Card Type and Firmware Version).
Call menu
Configure
button
9600 bps
Main Menu
----------
1: System Information
2: IP Network Settings
3: Messaging
4: Factory Settings
5: Firmware Updates
q: Quit and abort changes
x: Exit and save
Please select a key ?> 5