Emerson Liebert IntelliSlot IS-WEB485ADPT - Manual (Page 17)

Network Settings
13
5.1 Boot/IP Settings
The Boot/IP Settings Menu is used to set parameters for network
access to the Web card. Consult your network administrator for these
settings.
Terminal Emulation (Serial or TCP/IP Connection) / Telnet
To change any parameter:
1. Choose IP Network Settings from the Main Menu, then Boot/IP Settings.
2. Select an option to change—for example, Speed/Duplex, then enter settings according to the
following guide.
Web Interface
To access Boot/IP Settings through the Web interface:
• Click on the Configure tab, then Network Settings in the left panel and finally Edit beneath
the table of parameters and descriptions. After making changes, click Save.
Table 9 Boot/IP settings range
Parameter Description & Valid Settings*
Speed/ Duplex
Speed and duplex configuration of the Ethernet port.
• Auto (default—use this setting if unknown)
• 10Mbs/Half Duplex • 100Mbs/Half Duplex
• 10Mbs/Full Duplex • 100Mbs/Full Duplex
Boot Mode
Startup mode enabling the Web card to be a network-ready device.
• Static - Fixed network addresses and other parameters
• DHCP - Central management using dynamic network addresses
• BootP - Older mechanism for central management of network addresses
IP address
Network address for the Liebert unit.
Four numbers (0-255) separated by periods (.)—for example, 10.0.0.5
Netmask
Network mask that divides your network into manageable segments.
Four numbers (0-255) separated by periods (.)—e.g., 255.255.255.0
Default Gateway
IP address of the gateway for network traffic to other networks or subnets.
Four numbers (0-255) separated by periods (.)—e.g., 10.0.0.1
DHCP/BootP Server
Device on a network that assigns IP addresses that are not static.
Four numbers (0-255) separated by periods (.)—for example, 192.168.0.5
DNS Server
IP address of the Domain Name Server for the network.
Four numbers (0-255) separated by periods (.)—e.g., 10.0.0.1
* Consult your network administrator for proper settings.
Boot/IP Settings Menu
----------------------
1: Speed/Duplex
Auto
2: Boot mode Static
3: IP Address 192.168.0.125
4: Netmask 255.255.255.0
5: Default Gateway 192.168.0.1
6: DNS Server
0.0.0.0
: Cancel menu level
Please select a key ?>
Network
Settings
Edit
Configure tab