Epson Equity 320SX PLUS - Manual (Page 129)

Installing and Removing Disk Drives
The instructions in this chapter describe how to install and
remove optional Epson drives in your computer. You can use
these instructions to install a variety of devices, including
diskette drives, hard disk drives, and tape drives. Although
your drive may look a bit different from the one illustrated
here, you install it the same way.
If you are installing or removing a non-Epson drive, some of
the steps in this chapter may not apply; see the
documentation that came with your drive for more
information.
Before you perform any of the procedures described below,
follow the steps in Chapter 5 to remove the computer’s cover
and subassembly.
When you complete your drive installation or removal,
follow the instructions in Chapter 5 to replace the
subassembly and cover. Then see “Post-installation Setup
Procedures” at the end of Chapter 6 for information about
updating your drive configuration.
Caution
Installing or removing a disk drive is a complicated
procedure, so you may want to ask your dealer to do it for
you. If you decide to do it yourself, you must carefully
follow all the instructions in this chapter or you could
damage your equipment.
Installing and Removing Disk Drives 7-1