Epson Equity 320SX PLUS - Manual (Page 115)

6. Secure the end of the card to the back of the computer
with the retaining screw.
7. Follow the instructions in Chapter 5 to replace the cover.
Then see “Post-installation Setup” at the end of this chapter.
Removing on Option Card
If you need to remove an option card, follow these steps:
1. Remove the screw securing the card to the back of the
computer and pull it straight up and out of the slot.
2. Cover the option slot opening with the original metal
cover and secure it with the retaining screw.
3. If you are removing an option card that controls a
mouse, you need to change the setting of jumper J4 on
the main system board. If you are removing a display
adapter card, you may need to change the settings of
jumpers Jl, J3, and J5. See page 6-2 for instructions.
4. Replace the cover. See Chapter 5 for instructions. Then
see “Post-installation Setup” at the end of this chapter.
Imtalling and Removing Options 6-13