EverFocus PTZ SPEED DOME EPN3600 - Manual (Page 74)

EPN3600
74
2.7.2 Motion
Figure 2-59 Event – Event Tab
Motion Detection
User can define the motion area to be detected by left clicking the mouse to
draw lines. Every click is an end point of the line. When the detection area is
formed, double click the mouse to have all the lines connected. To remove
the selection, simply right click the mouse, the selected polygon will be
deleted.
Press
to update the current image.
Press to have the entire screen selected for motion detection.
Press to clear all selections.
Press and click on the polygon, to erase that polygon.
There are 5 motion trigger areas, which can be distinguished by 5 different
colors. Check Enable checkbox to enable event action.
For each of them, you can set the event action to be activated. Event action
can be set in “2.7.1 Event” section.