EverFocus PTZ SPEED DOME EPN3600 - Manual (Page 69)

EPN3600
69
Press Apply to apply the setting changes or Reset to reset without saving
the change.
2.7 EVENT
An event in the camera is when an Event Type is activated and causes certain
actions to be performed. The event type is the set of conditions that specifies
how and when which actions will be performed.
This table describes how to setup action types and event type.
Event Type
Action Type
Alarm
Input
Manual
Trigger
Auto
Tracking
Motion
Detection
Schedule
Recording
Pre/
Post-Alarm
Trigger Relay x x x x
Send Mail notification x x x x
Upload to FTP** x x x x x
Record to PC* x x x x x x
Network Alarm x x x x
Re-trigger x x x x
Go to PTZ preset x
Run Tour x
Run Pattern x
Note: 1. * Record to PC only works when PC and IP speed dome are connected.
2. **Either Upload to FTP or Record to Network Storage can be selected to
record event video to remote site.
3. Up to 10 event types can be configured in the camera, and up to 3 of these
can be configured to upload images .