EverFocus PTZ SPEED DOME EPN3600 - Manual (Page 26)

EPN3600
26
Password
: Input the password if the SMTP server requires authentication.
Receiver Address : Input the e-mail address for receiving e-mail message
when the EVENT is enabled and triggered. Please use “;” to separate
addresses.
Sender Address : Input sender’s e-mail address, so that receiver can
recognize the sender when an event message is sent out.
Send Test Mail : Click button to send a testing mail to the
assigned address.
Set FTP
The settings relating to the FTP server used to transmit the alarm images
can be configured here.
FTP Server
: Enter the IP address or the host name of the FTP server.
FTP Port: Enter the port number for FTP server. Default is 21.
Recording Path : Assign the recording path.
User Name : Set FTP User’s name.
Password : Set FTP password.
PASV mode
: Check to enable Passive mode. Normally enable Passive
mode. When failed to establish the connection, uncheck "PASV" mode.
Test FTP Server : Click button to send a testing file to the
assigned FTP server.
Click Apply to apply the setting changes or Reset to reset without saving
the change.