Enterasys Networks XSR-3020 - Manual (Page 38)

Installing a CompactFlash Memory Card
2-6 Hardware Installation
2. Seat the card in the PCMCIA interface as shown in Figure 2-8 .
Gently insert the CF into the slot, taking care that the CF’s wider grooved edge fits into the
wider track of the PCMCIA interface. If the card does not seat easily but stops halfway into the
slot, do not force it in - the card was inserted incorrectly. Flip it over and re-insert. Note that
the XSR’s CF eject mechanism pops out for easy removal when you install the card. Also, you
can re-attach the cover after the CF card is installed for added security.
Figure 2-8 Installing CompactFlash Card
CompactFlash Card for the ADSL NIM
The ADSL NIM is shipped with a CompactFlash card carrying the DSP firmware necessary for
connecting to a DSAM. Refer to
Figure 2-13 for an illustration and installation instructions.
Formatting the CompactFlash Card
If your CF is not formatted, there are two ways you can format the card:
• Use the XSR Bootrom Monitor Mode ffc command. A few seconds after you boot up the XSR,
press the CTRL-C keys and a password prompt will appear. Press ENTER (factory default) if
you have not defined any password. The Bootrom Monitor Mode will appear. Enter ffc and
the router will complete the formatting.
• Install the CF in a PCMCIA card and enter the Windows format command. For further
instructions, refer to Windows documentation.
• After completing CF formatting via Bootrom Monitor Mode, use the bc command to restart
the XSR in normal mode.
NIM 1
NIM 2
1000
GB IC
Link
TX
10/100/1000
10/100/1000
SEC URIT Y RO UTE RS
XSR-3020
COM
PWR
SYS
NIM1
NIM2
VPN
CO M
PW R
SY S
NIM1
NIM2
VPN
COM
ETH3
ETH2
ETH1