Enterasys Networks XSR-3020 User Manual
Page 100
Cable, CompactFlash and Accessory Specifications
A-14
Installing Shunt/Terminal Strip
To install the shunt or terminal strip, attach two dual-pin units vertically to each four-pin jumper
(P2, P3, P4, or P5) corresponding to the RJ-48C port using a balun, as shown in
. Any
other RJ-48C ports on the NIM card connected to 120-ohm lines do not require shunts.
Figure A-16 Installing a Grounding Shunt on the E1 NIM Card
See also other documents in the category Enterasys Networks Hardware:
- ANG-1100 (4 pages)
- MicroMMAC-T (108 pages)
- 7S4280-19-SYS (108 pages)
- ANG-1000 (70 pages)
- X-Pedition 2000 (86 pages)
- XSR 3000 Series (6 pages)
- XSR-1850 (25 pages)
- E1 Series (808 pages)
- 2E42_27R (77 pages)
- Fast Network 10 (132 pages)
- Enterasys Matrix 2G4082-25 (58 pages)
- DFE-256MB-UGK (5 pages)
- VHSIM2-A6DP (118 pages)
- 802.11 (202 pages)
- 802.11b PC Card (12 pages)
- Cabletron CyberSWITCH CSX5500 (729 pages)
- ROAMABOUT RBT-1602 (92 pages)
- 8000/8600 (142 pages)
- 6H308-48 (56 pages)
- SNS-TAG-HPA (34 pages)
- 6H308-48 (90 pages)
- XSR 1800 Series (5 pages)
- Aurorean Network Gateway 1100 Series (3 pages)
- FN 100 (54 pages)
- Network Ethernet Adapter BL-69108ENT (36 pages)
- Security Router X-PeditionTM (466 pages)
- BRIM-E6 (41 pages)
- X-PEDITION E9.1.7.0 (31 pages)
- XSR-3150 (110 pages)
- RBT-4102 (28 pages)
- 802.1Q (82 pages)
- Wireless Ethernet Adapter I (88 pages)
- Outdoor Antenna (66 pages)
- Network Card (276 pages)