Native Instruments KOMPLETE KONTROL S88 MK2 88-Key Controller for KOMPLETE - Manual (Page 27)

4.1 Connecting the Keyboard to the Computer
To connect the KOMPLETE KONTROL keyboard to your computer:
1.
Attach the device end of the included USB cable to the USB socket on the rear panel of
the keyboard.
2. Attach the computer end of the USB cable to an available USB 2.0 (or later) port on your
computer.
3. Press the power switch on the rear panel of the keyboard to switch it on.
→ The keyboard is now detected by the operating system.
Non-powered USB hubs are not supported. The keyboard should always be connected directly to the
USB port of the computer, or be used with a powered USB hub.
Setting up KOMPLETE KONTROL
Connecting the Keyboard to the Computer
KOMPLETE KONTROL S-Series - Manual - 27