Native Instruments KOMPLETE KONTROL S88 MK2 88-Key Controller for KOMPLETE - Manual (Page 128)

9.8.3 Assignments for Buttons
For the buttons, the Type menu offers the entries Control Change , Program Change , and Note .
Depending on the selected entry, a different set of additional parameters is available:
Type Mode Value Number Note
Control Change Toggle Off / On 0-127 0-127
Trigger 0 - 127
Program Change Toggle Off / On 0-127
Trigger 0 - 127
Note Toggle 0 - 127 C-2 – G8
Gate 0 - 127 C-2 – G8
Mode Menu Values for Buttons
For the buttons control elements listed in the above table, and only for some of the MIDI mes-
sage types available for these control elements, you can choose from different behaviors for the
way the data is sent. This is controlled by the
Mode menu. This menu can have up to four en-
tries, depending on the message type that you have selected in the Type menu. Here is the list
of all possible entries:
▪ Toggle: In this mode, the control element has two states, on and off. When you press once,
it switches to the on state — when you press again, it switches to the off state. For in-
stance, this can be useful for enabling and disabling an effect and check how it affects the
original sound. In this mode, there are two
VALUE settings: Off defines the value for the off
state (from 0 to 127, 0 by default), and On defines the value for the on state (0 to 127,
127 by default). For the Note message type, since the off state is predefined (it’s the MIDI
Note Off message), you find instead a single VALUE setting defining the velocity of the
MIDI Note On message.
Using the MIDI Assignment Editor
MIDI Message Types and Assignments
KOMPLETE KONTROL S-Series - Manual - 128