Native Instruments KOMPLETE KONTROL S88 MK2 88-Key Controller for KOMPLETE - Manual (Page 246)

The Mode setting consists of the following two modes:
▪ Arp mode, which generates arpeggiator sequences based on chords you play on the key-
board, or the output of the Scale engine. With ARP switched on and Mode set to Arp , any
chord you created using the Scale engine will play as an arpeggiated note sequence. In this
case, you only need to press one key on the keyboard to hear the arpeggiated notes play out
according to the selected scale.
▪ Note Repeat mode, which deactivates the Arpeggiator and instead repeats whichever note
is input until KOMPLETE KONTROL receives a MIDI note-off message. Use the parameters
Rate , Swing , and Gate to change the rhythm of the repeats.
16.5.2 MAIN Type
The second MAIN parameter, Type , is only available in Arp mode. On the keyboard, it is map-
ped to Knob 2 of the Control section in Arp Edit mode. It sets the sequential order of the ar-
peggiated notes. Choose whether your arpeggiated chord should be played from the root note
and up, the other way around, or even simultaneously. Selecting
Order Played will play back
the notes in the order you pressed down the corresponding keys on the KOMPLETE KONTROL
keyboard. Automating the
Type parameter in the host can create interesting variations and tex-
tures.
The
Type setting includes the following values:
▪ Up
▪ Down
▪ Up & Down ( UP-DOWN on the keyboard)
▪ Order Played ( PLAYED on the keyboard)
▪ Chord
16.6 RHYTHM Parameters
The RHYTHM parameters Rate , Sequence , and Swing allow you to create interesting rhythms
for the arpeggiator sequence.
Smart Play – Playing and Editing Arpeggiator Sequences
MAIN Parameters
KOMPLETE KONTROL S-Series - Manual - 246