Native Instruments KOMPLETE KONTROL S88 MK2 88-Key Controller for KOMPLETE - Manual (Page 251)

▪ 7
▪ 8
To display the set value of the OCTAVES parameter, tap Knob 6.
16.7.2 OTHER Dynamic
The second OTHER parameter, Dynamic , is only available in Arp mode. On the keyboard it is
mapped to Knob 7 of the Control section in Arp Edit mode. It reads the velocity of the input—
e.g. a key you pressed on the KOMPLETE KONTROL keyboard or an incoming MIDI note from
the host—and scales it by the factor you set with the
Dynamic parameter. The scaling is ap-
plied per note. The velocity of each played note is taken and multiplied by the value set with
the
Dynamic parameter.
Dynamic is a drag control that lets you set a value between 1.0% and 200.0% .
To display the set value of the DYNAMIC parameter, tap Knob 7.
16.7.3 OTHER Gate
The third OTHER Parameter, Gate , is available in both Arp and Note Repeat mode. On the key-
board, it is mapped to Knob 8 of the Control section in Arp Edit mode. It lets you decide the
length of the notes in your sequence. Setting a value between
1% and 99% makes the dura-
tion of the notes shorter than they otherwise would be. Setting a value between 101% and
200% instead elongates the duration of the notes by the selected value.
Gate is a drag control that lets you set a value between 1.0% and 200.0%.
The GATE RESET function, mapped to Button 4 of the Control section lets you reset the GATE
parameter to its default value of 100% at any time.
To display the set value of the GATE parameter, tap Knob 8.
Smart Play – Playing and Editing Arpeggiator Sequences
OTHER Parameters
KOMPLETE KONTROL S-Series - Manual - 251