Native Instruments KOMPLETE KONTROL S88 MK2 88-Key Controller for KOMPLETE - Manual (Page 126)

▪ Pitchbend: Sends MIDI pitchbend messages on a specific MIDI channel set by the Channel
parameter (range from 1 to 16, 1 by default). This message changes the pitch of the MIDI
notes sent on the same MIDI channel. Depending on the MIDI destination, it can also be
used to control other parameters.
▪ Off: Deactivates MIDI for the control element. Select this entry to disable the control ele-
ment or action. The control element/action does not send any MIDI message, hence no pa-
rameter is displayed.
9.8.2 Assignments for Knobs
For the knobs, the Type menu offers the entries Control Change and Program Change . Depend-
ing on the selected entry, a different set of additional parameters is available:
Type Mode RANGE Number Step
Control Change Absolute From 0-126 / To
1-127
0-127
Relative -32 to 31
Relative (Offset) -32 to 31
Program Change From 0-126 / To
1-127
Mode Menu Values for Knobs
For the type Control Change, a Mode menu allows you to select between three operating
modes:
▪ Absolute: In this mode the control element sends absolute values. The From , To , and Reso-
lution parameters are the same as for the other message types (see above).
▪ Relative: In this mode the sent message is in a +1/-1 fashion — actually 1/127, which is
then understood by the target software as +1/-1 in that case. This allows the control ele-
ment to set the new Control Change value relative to its current value. Two parameters are
available:
Using the MIDI Assignment Editor
MIDI Message Types and Assignments
KOMPLETE KONTROL S-Series - Manual - 126