Native Instruments KOMPLETE KONTROL S88 MK2 88-Key Controller for KOMPLETE - Manual (Page 131)

9.8.6 Assignments for Pedals (Switch)
For Pedals used as switch, the Type menu offers the entries Control Change and Program
Change . Depending on the selected entry, a different set of additional parameters is available:
Type Value Mode Val-
ue
Range Value Number Step Wrap
Control
Change
Toggle /
Gate
Off / On
0-127
0-127
Trigger 0 -
127
0-127
Inc Min / Max
(0-127)
-128 to 127 On/Off
Program
Change
Toggle /
Gate
Off / On
0-127
Trigger 0 -
127
Inc Min / Max
0-127
-128 to 127 On/Off
Mode Menu Values for Pedals (Switch)
For the button-like control elements listed in the above table, and only for some of the MIDI
message types available for these control elements, you can choose from different behaviors
for the way the data is sent. This is controlled by the
Mode menu. This menu can have up to
four entries, depending on the message type that you have selected in the Type menu. Here is
the list of all possible entries:
▪ Toggle: In this mode, the control element has two states, On and Off. If you press once, it
switches to the On state — if you press again, it switches to the Off state. This can be use-
ful for example for activating some effect, then deactivating it later. This is usually the de-
fault mode. In this mode, you find two numeric fields:
Off Value defines the value for the
Using the MIDI Assignment Editor
MIDI Message Types and Assignments
KOMPLETE KONTROL S-Series - Manual - 131