Denon DJ DJ SC6000M Prime Dual-Layer Media Player with 10.1" Multi-Touch Display - Manual (Page 14)

14
To jump to a specific location in the track :
• If Needle Lock is disabled : tap the desired location in the track overview.
•
If Needle Lock is enabled : pause playback and then tap the desired location in the track overview. Alternatively,
make sure the Motor is on , then stop the platter with your hand or palm to swipe through the track overview.
See Configuration > User Profile to learn about Needle Lock.
To zoom in and out of the waveform , place two fingers on the display and spread them apart or pinch them together.
Alternatively, turn the Select/Zoom knob.
Looping & Beat-Jumping
To create and activate an auto loop , press the Auto Loop knob.
To set the auto loop length , turn the Auto Loop knob to select the number of beats: 1 / 32 , 1 / 16 , 1 / 8 , 1 / 4 , 1 / 2 , 1 , 2 , 4 , 8 ,
16 , 32 , or 64 .
To create and activate a manual loop , press Loop In to set the start point, and then press Loop Out to set the end
point. The loop will be activated immediately, and the loop will be indicated as a shaded area in the waveform and
track overview.
To deactivate a loop , press the Auto Loop knob.
To move the loop , press and hold Shift and turn the Auto Loop knob while the loop is activated.
To double or halve the length of a loop , turn the Auto Loop knob while the loop is activated.
To manually edit the beginning or end of a loop, press Loop In or Loop Out respectively, then move the platter left or
right to shorten or extend the loop region. Commit the edit by pressing Loop In or Loop Out again.
To beat-jump through a track , press one of the Beat Jump buttons. Each press will skip through the track by the
length of an auto loop, which you can set by turning the Auto Loop knob.
Syncing & Pitch Adjustment
To activate sync , press Sync on the unit that you want to control the BPM, which becomes the “primary.” After Sync is
activated on that unit, press Sync on any additional units. The tempo of each unit will immediately synchronize to
match the tempo of the primary unit.
The Sync state icon in the display will indicate the current status:
Sync Off : Sync is deactivated.
Tempo Sync : Only the tempo is synced (the BPM will match that of the primary unit).
Bar/Beat Sync : The tempo will be synced, and the track will be automatically bar- or beat-matched with the
track on the primary unit, depending on the Sync Mode setting.
To deactivate sync on an SC6000M PRIME unit , press and hold Shift and press Sync .
To set a different SC6000M PRIME unit as the master , press Master . All connected units with Sync activated will use
the tempo of this unit. You can also tap Sync Lead on the touchscreen to select which layer on the primary unit is
used for sync.
To adjust the track’s pitch , move the pitch fader . You can do this only when the deck is not synced.
Important : If Sync is activated, moving the pitch fader on the “primary” SC6000M PRIME unit will change the speed
of all synced units, while moving the pitch fader on other units will do nothing.
To adjust the track’s pitch momentarily , press and hold one of the Pitch Bend – / + buttons.
To adjust the range of the pitch fader , press and hold Shift and press one of the Pitch Bend – / + buttons to select
+4% , 8% , 10% , 20% , 50% , or 100% .
To reset the track’s pitch to 0% , press and hold Shift and press Key Lock / Pitch Reset . The track’s pitch will return to
its original pitch ( 0% ) regardless of the position of the pitch fader.
To adjust the track's key, tap the key on the touchscreen to open the Key Change Menu .