Eaton Electrical 1000 User Manual
Page 17
GETTING STARTED
EATON Power Xpert
®
Gateway Series 1000 Card User’s Guide
S 164201670 Rev 1
13
9.
Type 2 and press Enter on the Network Settings menu (see
Figure 10 on page 11) to display the Network Settings: Ethernet
Port 2 menu (see Figure 14).
----------------------------------------------------------
------ Network Settings: Ethernet Port 2 ------
----------------------------------------------------------
1. Dynamic Addressing (DHCP) Enabled
2. IP Address
[None]
3. Subnet Mask
[None]
4. Default Gateway
[None]
MAC Address
00:60:26:10:89:A8
Link Status
Enabled
0. Exit to previous menu
Select an option ==>
Figure 14. Ethernet Port 2 Menu
10. Repeat Steps 2 through 7 to assign the IP address and other
options for Port 2.
11. If you will be using host names for controlling access to the card,
type 3 and press Enter. Type the primary DNS server IP address and
press Enter.
Type 4 and press Enter. Type the secondary DNS server IP address
and press Enter (see Figure 15).
---------------------------------------------------------
---------------- Network Settings ----------------
---------------------------------------------------------
1. Ethernet Port 1 Settings
2. Ethernet Port 2 Settings
3. DNS Server (Primary)
: 10.222.51.8
4. DNS Server (Secondary) : [None]
5. Reset to Factory Defaults and Exit
6. Save & apply all settings
0. Exit without saving
Select an option ==> 4
Figure 15. DNS Server Settings