BenQ MW855UST+ 3500-Lumen WXGA Ultra-Short Throw DLP Projector - Manual (Page 7)

Introduction 7
Introduction
Projector features
The projector offers the following features
• SmartEco™ starts your dynamic power saving
The SmartEco™ technology offers a new way of operating the projector lamp system
and saves lamp power up to 30% depending on the content brightness level.
• Interactive capability
Extend the interactive function with optional PointWrite module.
• Vertical 8% lens shift (No available in MH856UST)
Optimize the installation flexibility.
• Corner fit
Correct each distorted corner to get a perfect rectangular image.
• Filter Free
Filter free design to lower maintenance and operating costs.
• Network Control
Integrated RJ45 connector for wired network control allowing management of
projector status from a computer using a web browser.
Enable Network Standby mode <6W.
• Crestron RoomView
®
, and AMX supported
The projector supports Crestron eControl and RoomView and AMX allowing you to
control and manage equipment from a remote computer via LAN connection.
• One-key auto-adjustment
Pressing AUTO on the keypad or remote control to show the best picture quality
immediately.
• Built-in 10W x 2 speaker(s)
Built-in 10W x 2 speaker(s) providing stereo audio when an audio input is connected.
• Quick Cooling, Auto Power Off, Signal Power On, Direct Power On
Quick Cooling
function speeds up the cooling process when turning off the
projector. Auto Power Off function allows the projector to turn off automatically if
no input signal is detected after a set period of time. Signal Power On function turns
on your projector automatically once detecting the signal input and Direct Power On
boots up the projector automatically when the power is connected.
• The apparent brightness of the projected image will vary depending on the ambient lighting
conditions, selected input signal contrast/brightness settings, and is directly proportional to
projection distance.
• The lamp brightness will decline over time and may vary within the lamp manufacturers
specifications. This is normal and expected behavior.