BenQ MW855UST+ 3500-Lumen WXGA Ultra-Short Throw DLP Projector - Manual (Page 31)

Operation 31
Securing the projector
Using a security cable lock
The projector has to be installed in a safe place to prevent theft. Otherwise, purchase a
lock, such as a Kensington lock, to secure the projector. You can locate a Kensington lock
slot on the left side of the projector. See "Kensington anti-theft lock slot" on page 9 for
details.
A Kensington security cable lock is usually a combination of key(s) and a lock. Refer to the
lock’s documentation for finding out how to use it.
Utilizing the password function
For security purposes and to help prevent unauthorized use, the projector includes an
option for setting up password security. The password can be set through the On-Screen
Display (OSD) menu.
WARNING: You will be inconvenienced if you activate the power-on lock functionality and
subsequently forget the password. Print out this manual (if necessary) and write the password
you used in this manual, and keep the manual in a safe place for later recall.
Setting a password
Once a password has been set, the projector cannot be used unless the correct password is
entered every time the projector is started.
1. Open the OSD menu and go to the System Setup: Advanced > Security
Settings menu. Press MODE/ENTER . The Security Settings page displays.
2. Highlight Change Security Settings and press MODE/ENTER .
3. As pictured to the right, the four arrow keys
(
▲ / ▼ / ◄ / ► ) respectively represent 4 digits (1,
2, 3, 4). According to the password you desire
to set, press the arrow keys to enter five digits
for the password.
4. Confirm the new password by re-entering the
new password.
Once the password is set, the OSD menu
returns to the
Security Settings page.
5. To activate the Power on Lock function, press
▲ / ▼ to highlight Power on Lock and press ◄ / ► to select On .
6. To activate the Web Control Lock function, press ▲ / ▼ to highlight Web
Control Lock and press ◄ / ► to select On .
When the Web Control Lock is activated, you have to enter the correct password
to change projector settings via the Projector Network Display System.
The digits being input will display as asterisks on-screen. Write your selected password down
here in this manual in advance or right after the password is entered so that it is available to you
should you ever forget it.
Password: __ __ __ __ __
Keep this manual in a safe place.
7. To leave the OSD menu, press MENU/EXIT.
INPUT PASSWORD
Back MENU