HP L7016t 15.6" Retail Multi-Touch TN Monitor - Manual (Page 12)

5. To route cables with a stand attached, snap off the routing cover on the neck of the stand (1). Route the
cables down the neck of the stand, and then through the hole in the center of the base and out the
underside of the base (2). Snap the cable routing cover onto the neck of the stand to cover the cables
(3).
Installing an optional arm mounting bracket (for select models only)
The HP arm mounting bracket, sold separately, attaches a 25.7 cm (10.1-inch) or 35.6 cm (14-inch) monitor
model to the base of a retail system computer for use as a customer-facing display solution. Follow the
directions below to install the arm mounting bracket.
1. Lay the monitor face down on a flat surface covered by a soft clean cloth.
2. Place the arm mounting plate onto the rear of the monitor (1) and secure the arm to the monitor with
the four screws included with the arm mounting bracket (2).
6 Chapter 1 Getting started