HP L7016t 15.6" Retail Multi-Touch TN Monitor - Manual (Page 11)

Setting up the monitor
Installing an optional stand
The HP retail stands are sold separately. Follow the directions below to install the stand.
1. Lay the monitor face down on a flat surface covered by a soft clean cloth.
2. Place the stand mounting plate onto the rear of the monitor (1), and then install the two screws on the
top of the mounting plate (2).
3. Tilt the stand back to access the bottom of the mounting plate.
4. Install the two screws on the bottom of the mounting plate to secure the stand to the monitor.
Setting up the monitor 5