Epson DS-32000 Large-Format Document Scanner User Manual
Page 88
88
7.
Select from the following options:
• To change the saved file type, select
File Type
and select a file type.
• To change the color type of the scanned image, select
Image Type
and select an option.
• To change the resolution, select
Resolution
and select an option from either
Low
(200 dpi),
Medium
(300 dpi), or
High
(600 dpi).
• To change the size of the scanned original, select
Original Size
and select an option.
• To scan both sides of the original, select
Source
and select
2-Sided
.
• To change the number of copies to print when a printer is selected as the destination, select
Copies
and enter a number.
8.
If you want to change the scanner settings for the current job, select
Scanner Settings
on the
control panel.
Note:
If an administrator has locked the settings, you may need to enter the administrator password
to change certain scanner settings.
9.
Select from the following options:
• To increase the force used to separate originals in Delicate Mode, enable
Power Separation
Mode
(DS-32000).
Caution:
Do not use
Power Separation Mode
with thin originals, or you may damage them.
• To slow down the scanning speed, set the
Slow
setting to
On
.
• To stop scanning immediately when a double feed is detected, set the
Double Feed Stop Timing
setting to
Immediate
. When set to
After Eject
, the double feed is scanned and ejected before
scanning ends.
• To skip double feed detection when scanning originals such as envelopes or plastic cards, set the
DFDS Function
setting to
On
.
• To stop scanning immediately when a skewed original or feeding error is detected, enable the
Paper Protection
setting. When set to higher levels, the setting reduces the amount of skew
required to trigger a stop. Select higher settings when scanning thin papers. Select
Off
when
scanning plastic cards or thick paper. Lower the setting level if the scanner is too sensitive to
paper skew.
• To detect dirt on the scanner glass, enable the
Detect Glass Dirt
setting.