Sony AG-R2 Attachment Grip - Manual (Page 40)

Note
Tighten the screws firmly using the hex wrench included in the gimbal set (sold separately). Otherwise, the screws may loosen
and detachment may occur during flight.
When using tools other than the hex wrench included in the gimbal set (sold separately), be sure to tighten the screws with a
torque of 1.5±0.5 Nm.
Related Topic
Mounting the gimbal on the aircraft
5-027-737-11(1) Copyright 2021 Sony Group Corporation
Connect the control cable (aircraft — gimbal) ( ) to the control port ( ).
Insert fully until the plug locks into place.
Rear of aircraft
Connect the power cable (aircraft — gimbal) ( ) to the POWER port ( ).
Insert fully until the plug locks into place.
Connect the USB Type-C ® cable (aircraft — gimbal) ( ) to the USB port ( ).
40