Roland V-800HD MKII Multi-Format Video Switcher - Manual (Page 29)

29
Inputting HDCP Signals
By default, the V-800HD does not support HDCP (High-bandwidth Digital Content Protection). This means that HDCP-applied
signals from Blu-ray Disc players and the like cannot be input. When inputting signals to which HDCP is applied, follow the
procedure shown below to change the setting.
* HDCP is copyright-protection technology that prevents unlawful copying of content.
1. Display the System menu.
Press the [MENU] button to display the menu. Use the [CURSOR] buttons to select [System], then press the [ENTER] button to
display the System menu.
fig.open-system-menu.eps
2. Change the setting.
Use the [CURSOR] buttons to select [HDCP]. Turn the [VALUE] dial to change the setting from [OFF] to [ON]. A confirmation screen
appears. Press the [ENTER] button.
fig.HDCP-setting.eps
3. Exit the menu.
Press the [EXIT] button several times to quit the menu.
fig.close-menu.eps
When the setting change just described has been made, output from the SD OUT, SDI OUT, and RGB/COMPONENT OUT connectors will be
stopped. Note, however, that HDCP-applied output from the DVI-D/HDMI OUT connectors and output to the multi-view monitor will continue.
fig.HDCP-signal-flow.eps
RGB/COMPONENT OUT
DVI-D/HDMI OUT
SDI OUT
SD OUT
HDMI OUT
RGB/COMPONENT OUT
DVI-D/HDMI OUT
SDI OUT
SD OUT
HDMI OUT
OFF ON