Roland KD-A22 Kick Drum Converter - Manual (Page 4)

4
4. Connecting the Connector
1.
Turn the bass drum over so that the front surface is
upward.
2.
Remove the head and hoop.
3.
Connect the connector to the circuit board.
Convex
portion
Note the protrusion
on the connector
Note the orientation
of the connector
NOTE
Do not allow your fingers to touch the circuit board (especially
the edge or terminals). Doing so could cause injury or
malfunction.
5. Attaching the Front Head
1.
Place the front head on the shell.
2.
Place the hoop, and lightly tighten each lug, working
alternately across opposite sides of the drum, until the
lugs do not wobble.
3.
Then tighten each lug another 3/4 of a turn to secure the
front head.
6. Positioning the Kick Pedal
1.
Place the bass drum upright, and position the kick pedal.