Roland KD-A22 Kick Drum Converter User Manual

Introduction, Check the included items, When using a drum stand (mds-50k/mds-50kv)

Owner’s Manual

Watch the Quick Start Video

“Installing the KD-A22”

http://roland.cm/kd-a22

Introduction

The KD-A22 can be installed on a 22-inch acoustic bass drum.

Fully assembled view

* A 22-inch acoustic bass drum is not included with this product.

When using a drum stand (MDS-50K/MDS-50KV)

For the MDS-50K/MDS-50KV, the spacing of the bass drum installation area

is as follows.

Vertical:

590 mm (23-1/4”)

Horizontal:

620 mm (24-7/16”)

620 mm

(24-7/16”)

590 mm
(23-1/4”)

Check the Included Items

After opening the package, check that all of the included items are

present. If anything is missing, contact your dealer.

Front head

Batter head

NOTE

Do not pull the cable that is attached to the batter head.

Batter board

NOTE

A circuit board is attached to the batter board. To prevent injury,

damage, or accident, observe the following points.

Do not touch the circuit board with your fingers.

Do not lay down the batter board with the circuit board facing

downward.

Do not apply excessive force to the circuit board.

Batter hoop

* Batter board spacers (6 pcs.) are

already attached

Batter board stopper x 4

Connection cable

Drum key

Before using this unit, carefully read “USING THE UNIT SAFELY” and

“IMPORTANT NOTES” (p. 6). After reading, keep the document(s) where it will

be available for immediate reference.