Roland PD-108 V-Pad 10" (Black Chrome) - Manual (Page 8)

Connecting to the Percussion Sound Module
8
Replacing the Head or Hoop
Rubber
The performance of the head and/or hoop rubber
will diminish with use over time. If the head is torn or
becomes too fatigued, or impossible to tension correctly,
then it should be replaced. If the hoop rubber is worn
out, it too can be replaced.
For replacement heads or to have the hoop rubber
replaced, please contact your dealer or a Roland service
center.
Replacing the Head
NOTE
Applying excessive force to the sensor located
under the head can damage it and/or interfere with
accurate triggering.
1.
Remove all tuning bolts.
Go around and loosen each bolt a little at a time by
turning it counter-clockwise.
2.
Remove the hoop and old head.
3.
Place the new head and hoop on the shell
4.
Install all six tuning bolts.
5.
Adjust the tension of the head.
Refer to “Adjusting the head tension” above.
Replacing the Shell Covering
NOTE
• Applying excessive force to the sensor located
under the head can damage it and/or interfere with
accurate triggering.
• Be careful not to hurt your fingers on the corners or
points of the metal parts.
1.
Loosen all tuning bolts, and remove the hoop
and head.
2.
Hoop
Head
Do not touch the sensor
located at the top of the frame.
Remove the frame.
Frame
3.
Use a Phillips screwdriver to loosen the screw
that fastens the covering by approximately two
full turns.
Screw