Roland DJ-202 2-Channel, 4-Deck DJ Controller for Serato DJ Lite - Manual (Page 16)

16
System Settings
Pad Item Value (Bold: default) Explanation
R channel [3] Backspin length
OFF Short
Normal Long
When applying backspin to the jog dial, this setting lets you make backspin continue
longer than the distance that the jog dial actually rotated.
OFF
Backspin operation occurs according to the actual distance of rotation.
Short Backspin operation is shorter than with the Normal setting.
Normal Backspin operation occurs longer than the actual distance of rotation.
Long Backspin operation is longer than with the Normal setting.
Backing Up or Restoring Sequencer Data
Backup
Here’s how to back up patterns 1–16 and kits (instruments).
1. While holding down the mixer section’s SAMPLER [CUE] button,
use a USB cable to connect the DJ-202 to your computer.
The SEQUENCER section’s [START/STOP] button blinks, and the
performance pads blink.
2. On your computer, open the “Roland” drive.
3. Open the “BACKUP” folder, and copy all files from dj_prm_kit1.
prm through dj_prm_kit12.prm and dj_prm_ptn1.prm through
dj_prm_ptn16.prm to your computer.
4. When copying is completed, operate your computer to eject
the “Roland” drive.
5. Disconnect the USB cable to power-off the DJ-202.
Restore
Here’s how to restore the backed-up sequencer data from your computer to
the DJ-202.
1. While holding down the mixer section’s SAMPLER [CUE] button,
use a USB cable to connect the DJ-202 to your computer.
The SEQUENCER section’s [START/STOP] button blinks, and the
performance pads blink.
2. On your computer, open the “Roland” drive.
3. Copy the backup files into the “Roland” drive’s “RESTORE”
folder.
4. When copying is completed, operate your computer to eject
the “Roland” drive.
5. Press the SEQUENCER section’s [START/STOP] button.
The performance pads blink alternately, and then all performance pads
blink.
NOTE
Never turn off the power while the performance pads are blinking
alternately.
6. Disconnect the USB cable to power-off the DJ-202.
MEMO
Sequencer data is compatible between the DJ-202 and the DJ-505.
If the DJ-505’s sequencer data is restored to the DJ-202, aspects that
cannot be reproduced by the DJ-202 are automatically optimized.
Returning to the Factory Settings (Factory Reset)
The system settings and patterns stored in the DJ-202 can be returned to
their factory-set state (factory reset).
1. While holding down the [LOAD] button in the left side (L
channel) of the browser section, use a USB cable to connect
the DJ-202 to your computer, and continue holding down the
[LOAD] button until the SEQUENCER section’s [START/STOP]
button blinks.
* If you decide to cancel the operation, turn off the power.
2. Press the blinking [START/STOP] button.
Factory reset begins.
The MASTER level indicator blinks, and then all buttons and pads are lit.
NOTE
Never turn off the power while the MASTER level indicator is blinking.
3. After the factory reset is complete, disconnect the USB cable to
power-off the DJ-202.