Roland VC-1-SH SDI to HDMI Video Converter - Manual (Page 23)

23
Setting the Operation Mode
MODE SW 6/7
This specifies the audio channels assigned to signals from the AUDIO OUT
connectors. Combinations of 6 and 7 specify the assigned channels as described
below.
6 OFF 7 OFF Channels 1 and 2 assigned
6 ON 7 OFF Channels 3 and 4 assigned
6 OFF 7 ON Channels 5 and 6 assigned
6 ON 7 ON Channels 7 and 8 assigned
MODE SW 8
This selects the pre/post of audio embedding for SDI output.
OFF THRU. Signal before embedding (pre) is output.
ON OUT. Signal after embedding (post) is output.
MODE SW 9
This specifies whether HDCP is added to video output from the HDMI OUT
connector.
OFF
Video is output from the HDMI OUT connector according to the HDCP status of
HDMI input.
ON HDCP is applied to video output from the HDMI OUT connector.
MODE SW 10
This specifies the control mode.
* This also enables/disables the AUTO OFF function (p. 13).
OFF Mode is controlled by switches 1-9..
ON
The unit operates according to the settings in the internal memory (Set with VC-1
RCS software)
You can carry out detailed settings and save to unit’s internal memory using the dedicated
remote control software, the VC-1 RCS (p. 25).