Roland VC-1-SH SDI to HDMI Video Converter - Manual (Page 11)

11
Connecting the AC Adapter
Connect the AC adapter as shown in the figure below. Place the AC adaptor so the
side with the indicator (see illustration) faces upwards and the side with textual
information faces downwards.
* The indicator will light when you plug the AC adaptor into an AC outlet.
fig.connect-adaptor.eps
Indicator
Caution Regarding the Power Supply
Depending on the circumstances of a particular setup, you may experience a
discomforting sensation, or perceive that the surface feels gritty to the touch when
you touch this device or the metal portions of connected objects. This is due to an
infinitesimal electrical charge, which is absolutely harmless. However, if you are
concerned about this, connect the ground terminal (see figure) with an external
ground. When the unit is grounded, a slight hum may occur, depending on the
particulars of your installation. If you are unsure of the connection method, contact
the nearest Roland Service Center, or an authorized Roland distributor, as listed on
the “Information” sheet.
fig.earth-terminal.eps
Unsuitable places for connection
• Water pipes (may result in shock or electrocution)
• Gas pipes (may result in fire or explosion)
• Telephone-line ground or lightning rod (may be dangerous in the event of lightning)
About the Power Supply