Roland V-Combo VR-730 73-Key Live Performance Keyboard - Manual (Page 21)

Combining Two Sounds
21
Playing Drum Sounds in the Lower Part
You can play drum sounds in the lower part while playing a
different sound in the upper part.
Organ sound, etc . Drum sound
1.
Make split settings (p . 19) .
2.
Press the [DRUM] button to make it light .
The lower part will automatically switch to a drum sound.
* The sound setting for the upper part will not change.
Changing the Split Point
You can change the split point (the location at which the keyboard
is divided).
VR-09
Range in which you can specify the split point (C#2–C7)
Split point (Power-up: C4, included in left-hand zone)
C2 C4 B2 C3 C6 B5 C7
VR-730
Range in which you can specify the split point
(C#2–E7)
Split point (Power-up: C4, included in left-hand zone)
E1 B1 C2 C5 B4 C4 B2 C3 E7
1.
Press the ORGAN [SPLIT] button or SYNTH [SPLIT] button
to make it light .
2.
While holding down the [SPLIT] button you pressed in
step 1, press the key that you want to specify as the split
point .
The key you pressed will become the split point. The split point will
be the lowest key of the upper part.
MEMO
• While the split point screen is displayed, you can also change
the value by turning the [VALUE] dial.
• You can also specify the split point by using the [SPLIT] button
of the organ section or the synthesizer section.
• The split point setting is shared, regardless of the sounds you’re
combining.
Cancelling Split
1.
Press the [EXIT] button or the lit [SPLIT] button to make it
go dark .
Split will be cancelled.
The sound assigned to the upper part will now be heard across the
entire keyboard.
MEMO
You can also press any one of the MODE buttons to cancel split.