MIDEA MES30S4AST User Manual
Page 48
Problem:
Possible Reason:
Oven light is
not working
Oven light may be burned out. Follow instructions in
"Cleaning and Maintenance". If diaplay also show "]" or
"][" then Sabbath Mode setting must be turned off.
The oven will not start
self-clean
If oven was in use recently, this is normal. Self-clean can
only be initiated when the oven has cooled sufficiently.
Metal "popping" sounds
during self-clean.
This is normal as the extreme temperatures cause the
metal frame to expand.
After self-clean, the remaining white/grey ash must still
be wiped out by hand.
Oven not clean
after a self-
clean cycle.
If black soiling still remains, oven may have been too
heavily soiled to clean with the settings selected. Rerun
self-clean using the longest possible setting.
Some areas, such as bottom door corners, may be too
cool to turn soils into ash. These areas may need to be
cleaned by hand.
Convection fan runs in
modes other than
convection
This may be normal - convection fan typically runs during
preheat to ensure oven is evenly preheated.
Convection fan also runs in Convection Bake, Convection
Roast, Pizza, and Steam Clean
Hot air is coming from
the openings at the back
of the cooktop
This is normal - the oven vents out and a cooling fan also
discharges hot air from the openings at the back of the
cooktop.
It is normal for steam to be released from the oven vent
at the back of the cooktop. If the exhaust has no smell
(or smells like normal baking food), do not be alarmed.
If the exhaust smells like burning food, check that the
food is not burning and that there is no spillage or
splattering in the oven that may be producing the smoke.
Smoke or steam is coming
from the openings at the
back of the cooktop.
If the oven is in self-clean, this may be normal. Monitor
progress of self-clean to ensure smell is only the result
of soiling in the oven cavity being converted to ash.
If the exhaust smells like anything else is burning (plastic,
wood, etc.), turn oven off and make sure smoking stops.
Contact a qualified service provider for repairs
Cooling fan continues
to run after oven has
been turned off
This is normal to prevent remaining oven heat from
damaging controls. Fan will turn off when oven is
sufficiently cool.
This is a error code. Press CLEAR/OFF to clear the
display and stop beeping. If necessary, reset power to
the oven by cycling circuit breaker off and on. If error
code remains or repeats, write down error code and
contact a qualified service provider for repairs
"E" and a number
appears in display
PREPARING
FOR
FIRST
USE
COOKTOP
OPERATION
OVEN
OPERATION
CONTROL
SETTINGS
TROUBLESHOOTING
CLEANING
AND
MAINTENANCE
48
If cooktop is in use,self-clean cannot be started.This is
normal.
SAFETY
INSTRUCTIONS