MIDEA MES30S4AST - Manual (Page 47)

PREPARING
FOR
FIRST
USE
COOKTOP
OPERATION
OVEN
OPERATION
CONTROL SETTINGS
TROUBLESHOOTING
CLEANING
AND
MAINTENANCE
47
Problem:
Oven:
Unable to use
MSmartLife app
to control oven
Strong "burning" or
"oily" odor when using
new oven.
Control is dark and
will not respond
Control is on but
will not respond
Oven door is locked
and will not open.
This is normal with a new range and will disappear after
a few uses. Still, to be careful, you should double-check
that all packaging has been removed from the appliance
- check around door sides and inside drawer.
If control panel display shows only "]" or "] [", the
control is in Sabbath Mode. Refer to that section for
how to operate control and how to exit Sabbath Mode.
Check that CONTROL LOCK has not been activated.
If self-clean recently finished, this is normal. Wait for the
oven to cool fully and it will unlock. Otherwise, try
resetting the appliance by cycling the circuit breaker
off and on.
Oven is taking
too long to cook.
All ovens operate slightly differently from each other.
Adjust oven calibration upwards to make oven cook
faster. See "Control Settings" section of this manual.
Food is overcooked.
All ovens operate slightly differently from each other.
Adjust oven calibration downwards to reduce
overcooking. See "Control Settings" section of this
manual.
Food is not baking
evenly - top gets done
faster/slower than
bottom.
Make sure you are using the recommended rack settings.
See "Rack Positions" at the start of the "Oven Operation"
section.
Recipe may perform better at different rack position. Try
moving food down a rack position to make the bottom
darker. Try moving food up a rack position to make the
top darker.
Turning power off and back on at the breaker box can
usually reset the oven control and clear response issuses.
Condensation on door
glass
This is normal. Condensation will evaporate as oven
heats up.
D oor will not close
properly
Door is not installed properly. See instructions on
removing and re-installing door in "Cleaning and
Maintenance" section.
SAFETY
INSTRUCTIONS
Possible Reason:
If WiFi signal icon is flashing slowly, WiFi has not been
connected. See instructions in "Preparing For First Use."
is flashing quickly, WiFi signal has If WiFi signal icon
been lost. Check that router is on and no obstructions
are hindering signal. Can try to reset router and wait 15
minutes to reconnect. Otherwise repeat connection
instructions in "Preparing For First Use."
signal icon is off,
ress the button to en
If WiFi signal icon If WiFi
enabled. Press the
enabled. P
will turn on. icon