ProSoft Technology BM-xx00-RM1K - Manual (Page 8)

Preface
Page 8 of 48 ProSoft Technology, Inc.
April 21, 2015
1.1 Compliances
 This device MUST be professionally installed by a factory representative or a
trained authorized technician.
 Changes or modifications not expressly approved by the manufacturer may
void the user’s authority to operate the equipment.
 This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: 1) this device may not cause harmful interference,
and 2) this device must accept any interference received, including interference
that may cause undesired operation.
 To reduce potential radio interference to other users, install and use only the
antenna supplied by the manufacturer to ensure successful communications.
FCC RF Exposure
To comply with FCC RF exposure compliance requirements, a separation
distance of at least 20 cm must be maintained between the antenna of this
device and all persons.
FCC Interfere
This equipment has been tested and found to comply with the limits for a class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and if not installed and used in accordance with the instructions, may
cause harmful communications to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one of the following measures: