1preface – ProSoft Technology BM-xx00-RM1K User Manual
Page 7
Preface
ProSoft Technology, Inc.
Page 7 of 48
April 21, 2015
1
Preface
Thank you for choosing the Wireless I/O System - an intelligent, bi-directional
wireless I/O mirroring solution that is ideal for replacing hardwire and conduit or
for implementing it into new infrastructures. The Wireless I/O System requires no
software or prog
ramming and is extremely easy to install and use. It’s the easiest
way from point A to point B, and back.
This document is designed to guide you through setting up the system by
familiarizing you with the hardware, installation, wiring, and overall system
management. This guide also provides how to use the Wireless I/O
System’s
Advanced User Interface.
If you have any questions about this product, please call or email:
ProSoft Technology
5201 Truxtun Ave, 3rd Floor
Bakersfield, CA 93309
+1 (661) 716-5100
+1 (661) 716-5101 (Fax)
Warning: Ensure the installation of the system meets applicable state and national electrical code
requirements. The installation of the system should only be performed by a qualified installer or a
factory representative.
Warning: To prevent ignition of flammable or combustible atmospheres, disconnect power before
servicing.
Warning: Power must be disconnected or turned off prior to attaching or removing any I/O
Modules from the system – failure to comply may cause damage to the I/O Module(s).