ProSoft Technology BM-xx00-RM1K - Manual (Page 20)

Installation
Page 20 of 48 ProSoft Technology, Inc.
April 21, 2015
4.2 Wireless I/O System Assembly (attach from left to right)
Warning: Power must be disconnected or turned off prior to attaching or removing any I/O
Modules from the system – failure to comply may cause damage to the hardware.
1. Securely attach DataRail onto a 35 mm x 7.5 mm DIN rail by gently pressing
on all four (4) corner clips.
2. Secure DataRail to DIN rail by attaching an End Terminal Bracket.
a. First, hook the metal end of the Bracket to DIN rail and then snap the
other end onto DIN rail into place. (Make sure to position the Bracket on
the far left of the DataRail where the metal blades meet the plastic).