ProSoft Technology AN-X2-GENI - Manual (Page 32)

Page 26 AN-X2-GENI (AN-X-GENI/B) May 2013
Diagnostic Counters
The AN-X2-GENI maintains the following diagnostic counters.
Counter Offset Description
TxFrames 0 Transmitted network frames
TxMsgs 1 Transmitted network messages (datagrams)
RxFrames 2 Received network frames
RxMsgs 3 Received network messages (datagrams)
RxDup 4 Received duplicate frames
RxCrcErr 5 Received frames with a CRC error
RxStopErr 6 Received frames with a stop error
RxAbortErr 7 Received frames with an abort error
RxOverrunErr 8 Received frames with an overrun error
NoToken 9 No tokens received from network
To map the diagnostic counters, include a line with just the keyword DiagCtrs in the
input section of a connection. This maps all the diagnostic counters (10 words); they
cannot be mapped individually.
Example:
, DiagCtrs
Block Error Table
The block error table consists of 2 16-bit words, one bit per serial bus address. Bit 0 of
the first word corresponds to serial bus address 0, bit 1 corresponds to serial bus address
1, and so on.
If a configured block is not active on the network, the bit is 1. If a configured block is
active on the network, the bit is 0. The bit is always 0 for an unconfigured block.
To map the block error table, include a line with just the keyword BlockErr.
Example:
, BlockErr