ProSoft Technology AN-X2-GENI - Manual (Page 14)

Page 8 AN-X2-GENI (AN-X-GENI/B) May 2013
Quick Start
Step See page
1 Power up the AN-X, connect it to Ethernet and assign it
an IP address 8
2 (Not needed for existing installations) Use the Genius
hand-held monitor to assign serial bus addresses to
Genius devices and perform any other necessary
configuration.
3 Use the AN-X web interface to set the baud rate and
serial bus address for the AN-X2-GENI 16
4 Connect AN-X to the Genius network 5
5 Use the AN-X web interface to autoconfigure the
Genius network and ControlLogix configuration 16
6 Configure the AN-X in RSLogix 5000 31
7 Use the web interface to obtain aliases for RSLogix
5000 34
8 Import the aliases into RSLogix 5000 35
9 Use the aliases to access data