Web-based management, 1 introduction, 2 connecting to internet camera – PLANET ICA-HM830 User Manual
Page 25: 1 introduction 3.2 connecting to internet camera
3. Web-based Management
This chapter provides setup details of the Internet Camera’s Web-based Interface.
3.1 Introduction
The Internet Camera can be configured with your Web Browser. Before configure, please make
sure your PC is under the same IP segment with Internet Camera.
3.2 Connecting to Internet Camera
z
Use the following procedure to establish a connection from your PC to the camera.
z
Once connected, you can add the camera to your Browser’s Favorites or Bookmarks.
Start the web browser on the computer and type the IP address of the camera. The Default IP:
“
After connected to IP Camera, it
will prompt for User Name and Password, please enter
admin/admin
to continue Web Management. Confirm the installation as it is required to view the
video stream and some operations.
If difficulty is met, please refer to the following steps to establish the connection:
-
The IP Camera must be installed and powered ON.
-
If the IP Camera’s default IP Address (192.168.0.20) is already used by another device, the
other device must be turned OFF until the device is allocated a new IP Address during
configuration.
-
NOTE:
If the User name and Password have been changed with PLANET IPInstaller,
please enter the new User name and Password here.
25