PLANET ICA-HM830 - Manual (Page 12)

2.3 Hardware Installation
2.3.1 Physical Installation
Step 1. Prepare a PC with Ethernet link to the network
Step 2. Connect an Ethernet cable
Connect LAN port (RJ-45) of the IP Camera to a network switch. When this switch is
a PoE device, you can ignore the next step.
NOTE:
If there has an IEEE 802.3af PoE switch in your network, you can connect the IP
Camera LAN cable to this PoE switch to obtain power. The power adapter is
unnecessary when IP Camera is connected to a PoE switch.
Step 3. Attach the power supply
Plug in power adapter to IP Camera and connect another end to power outlet.
NOTE:
Only use the power adapter supplied with IP Camera otherwise, the product may
be damaged.
Step 4. Plug Power on 110v or 220V
Ensure the power adaptor specification matches the power system (110V AC or
220V AC) and connect the adaptor to the outlet
Step 5. Check LED status
The Power LED is defined to identify IP Camera status. When IP Camera booting
the LED will be flashing and while IP Camera is ready the LED will be green.
12