PLANET ICA-107 - Manual (Page 9)

2.2.2. Rear Panel
y Power Input
The DC power input connector is located on the IP Camera's rear panel, and is labeled 5V DC
with a single jack socket to supply power to the IP Camera. Power will be generated when the
power supply is connected to a wall outlet.
y Ethernet Jack
The IP Camera's bottom panel features an RJ-45 connector for connections to 10Base-T
Ethernet cabling or 100Base-TX Fast Ethernet cabling (which should be Category 5 twisted-pair
cable). The port supports “Auto-MDIX” function, allowing the IP Camera to automatically detect
or negotiate the transmission speed of the network.
y Reset Button
Press the reset button for more than 10 seconds and the IP Camera will reset to the factory
default. The factory default settings are listed in the table below.
y WPS Button (ICA-107W only)
Press the WPS button for less than 2 seconds, machine will start WPS function to build
connection between wireless network clients and the WPS activated Access Point.
y Mounting hole
The mounting hole is provided for IP Camera stand installation.
Mounting hole
Reset /
WPS Button
(ICA-107W only)
Power Input
Ethernet Jack
Bottom View of IP Camera
(Example on ICA-107W)
5