PLANET ICA-107 - Manual (Page 33)

29
tion mode requires the presence of a Wireless
LAN Access Point or Router. All communication is done via the Access
Point or Router.
Ad-Hoc – Select this mode if you want to connect to another wireless
stations in the Wireless LAN network without through an
Access Point or Router.
function is disabled.
Network Type Infrastructure – This opera
Available Networks Select the networks listed below and click apply to connect to the
specified network.
SSID The SSID (up to 32 printable ASCII characters) is the unique name
identified in a WLAN. The ID prevents the unintentional merging of two
co-located WLANs.
You may specify a SSID for the IP Camera and then only the device with
the same SSID can interconnect to the IP Camera.
Channel This setting is only available for Ad-Hoc mode. Select the number of the
radio channel used for the networking.
Basic Rate The IP Camera will force to the data rate that you selected to transmit
data.
Authentication Choose the security setting of your wireless network.
The ICA-107W supports: “None”, “Open System”, “Shared Key”,
“WPA-PSK” and “WPA2-PSK”. When you select “WPA-PSK” or
“WPA2-PSK” yption your wireless with TKIP
or AES.
authentication, you can encr
WPA Pre-Shared Key The WPA-PSK / WPA2-PSK key can be from 8 to 64 characters and can
be
th
letters or numbers. This same key must be used on all of the node in
e wireless network.
WEP Key Length Y d data. Larger key ou may select 64-bit or 128-bit to encrypt transmitte
length will provide higher level of security, but the throughput will be lower.
WEP Key Format H
ke
A allowed to be WEP key.
It
exdecimal – Only “A-F“, “a-f“ and “0-9“ are allowed to be set as WEP
y.
SCII – Numerical values, characters or signs are
is more recognizable for user.
Default Key Select one of the keys (1~4) as the encryption key.
Key1 ~ Key4 Enter the WEP key you want to use here.
Apply W
se
hen you finish “WLAN” configuration, click this button to apply the
tting.