PLANET DVR-1672 - Manual (Page 40)

34
Item Description
Enable HTTP Server Check to enable HTTP server. Users can remotely access into the DVR
over the network if the HTTP function is activated.
Port Enter a valid port value from 1 up to 65535. The default value is 80.
Quality and Frame Rate Setup for Network Transmission
No. Check to activate the transmission of each camera.
Quality Choose from Below Basic / Basic/ Normal/ High/ Highest.
FPS Choose recording frame rate (1~30FPS).
Auto
The maximum recording frames available by the average distribution of
each channel (totally 60FPS).
This video streaming is used for network transmission; setting is LQ (low quality). Under a low bandwidth
capacity, this stream can send out small picture and keep a good video quality and smooth display rate. If
the bandwidth is large enough, it can be adjusted to HQ (high quality). Thus, the network streaming will be
switched to the condition which this DVR is recording. Therefore, a larger video image can be sent to
remote site.
5.7.3 DDNS Setup
Item Description
Enable DDNS Check/ Uncheck to Enable/ Disable DDNS function.
DDNS Server Enter the registered SMTP Server:
DYNDNS.ORG, NO-IP.ORG, CUSTOM.COM
Host Server Enter the registered SMTP Server.
User Name Enter user name.
Password Enter password.