PLANET WNAP-W2200 - Manual (Page 38)

User Manual of WNAP-W2200
-30-
1. Click "Choose file” to locate the firmware and "Update” to upgrade.
2. AP will reboot automatically when upgrade completes.
Do not disconnect the device from your management PC (the PC you use to
configure the device) or power off it during the upgrade process; otherwise, it may be
permanently damaged. The device will restart automatically when the upgrade
process, which takes several minutes, completes.
5.6.2 Reboot
This page is used to reboot wireless access point. Rebooting the device makes the settings configured go into
effect.
Figure 5-12 Reboot
 Reboot: Click this button to reboot the device.
5.6.3 Logs
The section is to view the system log. Click the “Refresh” to update the log. Click “Clear” to clear all shown
information. If the log is over 150 records, it will clear them automatically.