PLANET WNAP-6305 - Manual (Page 66)

User’s Manual of WNAP-6305
- 66 -
Reset OOB Click Reset OOB button to reset WPS AP to the OOB (out-of-box)
configuration.
WPS mode Select WPS mode. PIN: Personal Identification Number. PBC: Push
Button Communication.
PIN Input enrollee’s PIN code to AP-registrar.
Step 2. To add a new device:
If the wireless adapter supports Wi-Fi Protected Setup (WPS), you can establish a wireless connection
between wireless adapter and Router using either Push Button Configuration (PBC) method or PIN
method.
To build a successful connection by WPS, you should also do the corresponding
configuration of the new device for WPS function.
I. By Push Button Configuration (PBC)
If the wireless adapter supports Wi-Fi Protected Setup and the Push Button Configuration (PBC)
method, you can add it to the network by PBC with the following two methods:
Step 1: Choose PBC, and click “Apply”.
Figure 5-34 WPS - PBC
Step 2: Press and hold the WPS Button equipped with the adapter directly for 2 or 3 seconds. Or
you can click the WPS button with the same function in the configuration utility of the
adapter.
1) Step 1 & 2 should process within two minutes.
2) WNAP-6305 only supported Software PBC.
Step 3: Wait for a while until the connection is established to complete the WPS configuration.