PLANET WNAP-1110 - Manual (Page 54)

suitable access control settings), but the new value would be forgotten the next time the agent was
restarted.

Get Community - Enter the community name that allows Read-Only access to the AP's
SNMP information. The community name can be considered a group password. The default
setting is “public”.
 Get Source - Get source defines the IP address or subnet for management systems that can
read information from this 'get' community device.

Set Community - Enter the community name that allows Read/Write access to the AP's
SNMP information. The community name can be considered a group password. The default
setting is “private”.

Set Source - Set source defines the IP address or subnet for management systems that can
control this 'set' community device.

Note:
A restricted source can be a specific IP address (e.g. 10.10.10.1), or a subnet - represented as
IP/BITS (e.g. 10.10.10.0/24). If an IP Address of 0.0.0.0 is specified, the agent will accept all
requests under the corresponding community name.
Click the Save button to save your settings.
4.7.2 Diagnostic
Selecting System Tools > Diagnostic allow you to check the connections of your network
components on the screen shown in Figure 4-31.
Figure 4-31 Diagnostic
Diagnostic Tools - Click the radio button to select one diagnostic tool
48