PLANET WNAP-1110 - Manual (Page 27)

1) Access Point: This mode allows wireless stations to access this device.
Figure 4-8 Wireless Settings in Access Point mode
 SSID (Set Service Identifier) - Identifies your wireless network name. Create a name up to 32
characters and make sure all wireless points in the wireless network with the same SSID. The
default SSID is
default . This value is case-sensitive. For example, default is NOT the same
as DEFAULT.

Channel - Determines the operating frequency to be used. It is not necessary to change the
wireless channel unless you notice interference problems with another nearby access point.

Mode - Select the desired wireless mode. The options are:
 11b only - Only 802.11b wireless stations can connect to the AP.
 11g only - Only 802.11g wireless stations can connect to the AP.
 11n only - Only 802.11n wireless stations can connect to the AP.
 11bg mixed - Both 802.11b and 802.11g wireless stations can connect to the AP.
 11bgn mixed - All 802.11b, 802.11g and 802.11n wireless stations can connect to the
AP.
 Channel Width - Determines the channel width to be used. It is unnecessary to change the
default value unless required.
 Max Tx Rate - Specifies the maximum transmit rate of the AP through this field.
 Enable Wireless Radio - Select or deselect this check box to allow or deny wireless stations
to access the AP.
21