PLANET WNAP-1110 - Manual (Page 29)

wireless channel unless you notice interference problems with another nearby access point.

Mode - This field determines the wireless mode which the device works on.
 11b only - Only 802.11b wireless stations can connect to the AP.
 11g only - Only 802.11g wireless stations can connect to the AP.
 11n only - Only 802.11n wireless stations can connect to the AP.
 11bg mixed - Both 802.11b and 802.11g wireless stations can connect to the AP.
 11bgn mixed - All 802.11b, 802.11g and 802.11n wireless stations can connect to the
AP.

Channel Width - Determines the channel width to be used. It is unnecessary to change the
default value unless required.

Max Tx Rate - Specifies the maximum transmit rate of the AP through this field.

Enable Wireless Radio - Select or deselect this check box to allow or deny wireless stations
to access the AP.

Enable SSID Broadcast - Select or deselect this check box to allow or deny the AP to
broadcast its name (SSID) on the air. If it’s allowed, when wireless clients survey the local
area for wireless networks to associate with, they will detect the SSID broadcast by the AP.

Note:
To apply any settings you have altered on the page, please click the Save button, and then you
will be reminded to reboot the device.
3) Client: This mode allows the AP to act as a wireless station to enable wired host(s) to access
an AP.
Figure 4-10 Wireless Settings in Client mode
 Enable WDS - The client can connect to AP with WDS enabled or disabled. If WDS is
enabled, all traffic from wired networks will be forwarded in the format of WDS frames
23